Several years ago, Draper introduced the Access line of projection screens as a breakthrough in screen design. The concept was born out of input from our customers, and the Access is one of our most popular products. < p>Today the Access has been redesigned, again based on customer input. The improvements make better use of the limited space above the ceiling, and make the Access even easier to install.< /p> < p>The Access E is a motorized screen for ceiling-recessed installation. It is now available in larger sizes--through 16' wide--which formerly required the larger Access XL. Smaller sizes, through 10' wide, have been repackaged into a compact housing, less than 6" tall, and are now known as Access FIT. (Check Related Products below for links to the Access FIT and Access XL).< /p> < strong>Case Now, Screen Later< /strong> < p>You can install the case during the "dirty" phase of the construction process and keep the screen safe until you install the projector. The screen (motor-in-roller and attached viewing surface) installs in seconds with preset latching roller brackets and electrical pin connectors. This eliminates job site damage. Screens may be installed in cases up to 20" wider than the standard case lengths.< /p> < p>Some optional controls, including LVC-IV may be built into the case. If you want built-in Low Voltage Motor, Quiet Motor or control options you must specify when ordering to assure compatibility with your screen.< /p>
